Polymer - Approved Technicians Practical End Test - City of Wolverhampton College
OR

Polymer – Approved Technicians Practical End Test Study Mode: Part-time   |    Course Level:

Candidates should have been employed within an injection moulding environment for a period of no less than 4 years and have significant experience of the process requirements and troubleshooting from a leading role within an Injection Moulding operation. Ideally, candidates should have attended and passed the Injection Moulding Technology Level 3 course prior to attending the practical assessment.

Candidates involved in processing, troubleshooting, tool commissioning and R&D activities of existing and new production requirements.

During the assessment, the delegates will be expected to:

  • Check the installation of a loaded tool against information provided
  • Establish settings from a zero base. Machine will not move until candidate enters values
  • Conduct full safety guard checks
  • Start production and make adjustments to processing conditions as they see fit in order to produce acceptable parts within specification, at the correct weight and within stated cycle time
  • Produce samples for approval by the PTIC invigilator
  • Shut down and fully isolate machine and all ancillary equipment
  • All scrap parts are to be granulated and work area is left in an appropriate condition
  • In addition, the candidate should complete the IMT3 test if not undertaken within the 2 years prior to attending the assessment.
Print
Location
Start Date
Day
Time
Course Fee
Course Code
Study Mode
Location

Telford Campus

Start Date

Day

Time

Course Fee

Course Code

PTICATPET

Study Mode

Part-time

Events

Case Studies