Polymer - Approved Technicians Practical End Test - City of Wolverhampton College

Polymer – Approved Technicians Practical End Test

Apply Now

Study Mode: Course Level:
Print Print/PDF

Candidates should have been employed within an injection moulding environment for a period of no less than 4 years and have significant experience of the process requirements and troubleshooting from a leading role within an Injection Moulding operation. Ideally, candidates should have attended and passed the Injection Moulding Technology Level 3 course prior to attending the practical assessment.

Candidates involved in processing, troubleshooting, tool commissioning and R&D activities of existing and new production requirements.

During the assessment, the delegates will be expected to:

  • Check the installation of a loaded tool against information provided
  • Establish settings from a zero base. Machine will not move until candidate enters values
  • Conduct full safety guard checks
  • Start production and make adjustments to processing conditions as they see fit in order to produce acceptable parts within specification, at the correct weight and within stated cycle time
  • Produce samples for approval by the PTIC invigilator
  • Shut down and fully isolate machine and all ancillary equipment
  • All scrap parts are to be granulated and work area is left in an appropriate condition
  • In addition, the candidate should complete the IMT3 test if not undertaken within the 2 years prior to attending the assessment.


Start Date




Course Fee

Study Mode

Case Studies


Ready To Join Us?